Materials:
a. thick paper approximately 120g
b. glue
c. scissors
d. ruler
e. cutter
Preparation:
a. Get the pattern (here)
b. suitable scissors pattern truck pictures
c. fold the edges and give the glue
d. paste per part so as to form a model truck
Modification:
This pattern can be modified in order to get a model truck that has a wheel that can rotate, and the trailer could move. Materials that need to be added is some roll tape that has been unused or buy at an electronics store nearby, adjust the size of a large roller truck models to be created. And wire for the steering wheel, adjust the size.
Step to modification:
Pattern of existing trucks, separating between the head of the truck with the container. Cutout the pattern forming section 2 pattern. Add some sides of the head cover and tow trucks so as to form a perfect part. Do not forget to cut out the pattern of the wheel so that the tape roll can be installed.
Pattern 1 (head part) & Pattern 2 (back part: container) |
Rubber roller tape recorder |
It should be added to the truck chassis as the wheel axle.
Front & back chassis of the truck |
Straws are glued on the front of the truck is used to connect the container with the front of the truck.Do not forget to make holes in the container for a straw into the hole.
Complete pattern of container truck is :
Truck head pattern |
Container pattern |
*) All of the above patterns still need to be adjusted.
The other TRUCK models :
Wait new release of
container truck models
describe beside